Thanks for getting back to me. I have been running several tests on two =
Sparc machines both running on 100Mb link via switch (100Mb CISCO). From =
both ends I ran netserver then the netperf commands as shown below. Why =
am I getting a different throughput link on both cases ? I deally I =
though they should be the same !! I have been trying to check whether =
the problem could be one of full- or half- duplex link setting, but with =
no much success.
Anyone with ideas, I'll appreciate !! The outputs are show below.
Martin.
> netperf -p 5400 -H 139.133.204.104 -t UDP_STREAM -- -m 1472=20
UDP UNIDIRECTIONAL SEND TEST to 139.133.204.104 : interval
Socket Message Elapsed Messages =20
Size Size Time Okay Errors Throughput
bytes bytes secs # # 10^6bits/sec
8192 1472 10.00 79891 0 94.11
8192 10.00 102 0.12
> netperf -p 5400 -t UDP_STREAM -H 139.133.204.110 -- -m 1472
UDP UNIDIRECTIONAL SEND TEST to 139.133.204.110 : interval
Socket Message Elapsed Messages =20
Size Size Time Okay Errors Throughput
bytes bytes secs # # 10^6bits/sec
8192 1472 10.00 27576 0 32.49
8192 10.00 27369 32.24